Share |

Re: 430 Stainless Steel


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Randy on March 28, 2002 at 21:40:02:

In Reply to: 430 Stainless Steel posted byA. Au on March 18, 2002 at 08:26:17:

IF ... there was trace amounts of aluminum in 430 stainless it would be there to provide impurities between the crystallines to improve plasticity. Not something I relate to when I spec a stainless. So it would make it more maluable or shapeable by allowing the structure to slide (if you would) around just a little. I would expect a high heat treat process to burn out or release a good amount of this 'aluminum trace'.
A good book on metalergy would explain this throughly.


Follow Ups



< "> Subject: Re: Re: 430 Stainless Steel

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer