Posted ByCragyon on April 11, 2002 at 08:01:00:
For all you great minds out there, in your organization what belongs on the assembly print and what should reside on the traveler?
We only put mechanical end item information on a print. Some on the stuff as follows:
Torque pattern (If required)
Special assembly procedures
Views that clearly depict assembly
Any information that is important to the end item assembly
We do not:
Glue and goos mix procedure
How to solder
How to torque (calibration, how to hold torque wrench etc)
Refer to Travelers
Refer to special internal processes
I know there is alot more!
Are we typical?
< "> Subject: Re: Traveler vs Print
[ Home ][ Forum Archive ] [ Active Engineering Forum ]
© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved. Disclaimer