Share |

S303 outer threads and S303 threaded shaft=problems?


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Ralph Rivers on April 19, 2002 at 15:03:57:

This scenario is on an existing part we have had since before I was with the company. I am not an engineer so I would like yor opinion. it is basically a threaded shaft and a threaded knuckle screwing into each other, both made of S303 stainless steel. Should I demand that the "bolt" part of it be made of a different material?


Follow Ups



< "> Subject: Re: S303 outer threads and S303 threaded shaft=problems?

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer