Share |

Re: S303 outer threads and S303 threaded shaft=problems?


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Ralph Rivers on April 26, 2002 at 12:59:02:

In Reply to: S303 outer threads and S303 threaded shaft=problems? posted byRalph Rivers on April 19, 2002 at 15:03:57:

: Initially we assumed we had a problem with this feature due to the machinists raising flags, but after further observation I am happy to report that our material selection was correct. As Cragyon pointed out, the worry the machinists had was due to galvanic incompatibility, but with regard to this material and inspection we fouind no cause for changes to take place.
Thank-you much with regard to the great replies,and I apologize for not getting back sooner.



Follow Ups



< "> Subject: Re: Re: S303 outer threads and S303 threaded shaft=problems?

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer