Share |

Looking for #8 Tapping screws with a #6 Flat head


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Bob on April 30, 2002 at 12:49:14:

I have a need for a undersized flat head on a number 8 tapping screw. I need only a small amount for prototyping before needing high volumes. Does anyone know of a off the shelf source for these screws? Need them to be a #6 flathead with a #8 screw from 1/2" to 1" with a torx drive in steel type AB point.

Thanks in advance for any advice.
B.S.


Follow Ups



< "> Subject: Re: Looking for #8 Tapping screws with a #6 Flat head

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer