Share |

Re: Stainless Steel Finish ANSI B 46.1


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Mike McGuire on May 23, 2002 at 14:18:24:

In Reply to: Stainless Steel Finish ANSI B 46.1 posted byBill Pennock on April 23, 2002 at 12:54:41:

: What is the standard mill finish 2B and #4 finish equal to in rms? I need an equivalant to 32rms per ANSI B 46.1.

: Thanks
: Bill

There is no standard for roughness in either finish. The normal Ra for 2B is under 10 microinch-it depends on gauge. For #4 it is normally between 5 and 15 microinch.


Follow Ups



< "> Subject: Re: Re: Stainless Steel Finish ANSI B 46.1

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer