Re: Metric Shaft and Hole Tolerance


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">ahmed gouda on May 24, 2002 at 04:18:45:

In Reply to: Metric Shaft and Hole Tolerance posted bygoflyers on February 08, 2002 at 10:23:09:

: I need some advice on finding ISO tolerance for shafts and holes (h7, h6, ... etc). I know that there has to be a simple place to find this but all I can find are the sights that want $60 for the official spec.
: Thank You,




Follow Ups



Subject: Re: Re: Metric Shaft and Hole Tolerance

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved.  Disclaimer