Share |

tol


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Bhogilal on July 04, 2002 at 23:45:19:

I have one shaft with dia.100 and one hole of dia.100
hole to be done in gear.
i have to fit it with aditional forces.(i.e.interfearance fit)

my question is "Which tolerance to be given on shaft and hole to get interfearance fit?"

thanks in advance. please explain step by step.

thanks


bhogilal suthar


Follow Ups



< "> Subject: Re: tol

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer