Share |

Re: tol

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">John Paul on July 05, 2002 at 02:07:44:

In Reply to: tol posted byBhogilal on July 04, 2002 at 23:45:19:

Hi there!
I will suggest you use a H6 tolerance on shaft and N7 (steel) or R7 (aluminuim) outer hole
Any question, here I am.
Keep it simple!

: I have one shaft with dia.100 and one hole of dia.100
: hole to be done in gear.
: i have to fit it with aditional forces.(i.e.interfearance fit)

: my question is "Which tolerance to be given on shaft and hole to get interfearance fit?"

: thanks in advance. please explain step by step.

: thanks

: bhogilal suthar

Follow Ups

< "> Subject: Re: Re: tol


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer