Share |

position tolerance calculation and its formulas


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">shivaji nilakanth on August 04, 2002 at 01:18:46:

i have a shaft on which three holes equispaced at 120 deg angles and p.c.d is 26 mm. Tap size is M6 x 1 mm thread forming operation. Center locating dia is 10 +/- 0.025 and MMC given is 0.50 max. how to calculate the p.c.d gauge size and its pin sizes to accomodate the 0.50 position tolerance. please suggest me with supporting formulas and documents.

thanks
regards

shivaji nilakanth


Follow Ups



< "> Subject: Re: position tolerance calculation and its formulas

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]