Share |

Re: true position on a round part


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Randy Kimball on August 10, 2002 at 15:57:51:

In Reply to: true position on a round part posted byFrank on July 24, 2002 at 15:33:41:

Frank,
I expect this answer is a bit weak and late but here it is.
A round part in a circle is usually called as cocen. If it
is called out as true position (odd) if it is in the center
but common if it is off center and you are off .010" at a
45. You are now off .00707" in both X and Y. As you
know this adds up fast in true position.




Follow Ups



< "> Subject: Re: Re: true position on a round part

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer