Share |

ASME Section VIII Appendix Y (flange) calcs


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Allen Forsman on August 19, 2002 at 07:41:43:

I am attempting to perform Appendix Y stress calculations on a custom flange design for a test article. Two of the stress formulas, Eq's. 15a (tangential flange stress at ID) and 16a (longitudinal hub stress) refer to a variable (theta sub B = slope of flange face at inside diameter, rad). No other references to this variable or how it is obtained can be found in Appendix Y or in Appendix 2. Any idea where this comes from? Any help would be greatly appreciated.


Follow Ups



< "> Subject: Re: ASME Section VIII Appendix Y (flange) calcs

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer