Membership Services

Re: Naming Convention

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted ByCragyon on August 28, 2002 at 09:00:43:

In Reply to: Naming Convention posted byDave Sargent on August 16, 2002 at 10:13:13:

"Would appreciate any assistance in researching / locating typical part naming procedures / guidlines. Anyone with documented layouts or possible internet resources - please reply."

The following is typical per mil-t-31000 and mil-c-100.

Noun Name, Modifier, Modifying Phrase - Modifying Phrase, Modifier

Example:

Guide, SHAFT, BUTTERFLY VALVE- .010 INCH OVERSIZE, LOWER

When using the words "ASSEMBLY", "INSTALLATION" or SUBASSEMBLY in a basic name, it appears as the last word in the noun phrase (first part) and may b abbreviated.

Follow Ups

Re: Re: Naming Convention . 20:27:27 01/30/03 (0)

Subject: Re: Re: Naming Convention

Comments:: "Would appreciate any assistance in researching / locating typical part naming procedures / guidlines. Anyone with documented layouts or possible internet resources - please reply." : : The following is typical per mil-t-31000 and mil-c-100. : Noun Name, Modifier, Modifying Phrase - Modifying Phrase, Modifier : Example: : Guide, SHAFT, BUTTERFLY VALVE- .010 INCH OVERSIZE, LOWER : When using the words "ASSEMBLY", "INSTALLATION" or SUBASSEMBLY in a basic name, it appears as the last word in the noun phrase (first part) and may b abbreviated.

[ Home ][ Forum Archive ] [ Active Engineering Forum ]