Share |

tonneage requirements to punch UHMW.


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Dennis Wagner on August 28, 2002 at 17:23:24:

I'm quoting build a die to stamp .984 dia. x .009 thick washers with a .328 dia. thru hole in UHMW. I need to calculate the tonneage requirements & haven't been able to find anything in on-line reference publications. I would appreciate if anyone knows of a website that covers tonneage calculations for punching sheet plastic. Regards, Dennis Wagner


Follow Ups



< "> Subject: Re: tonneage requirements to punch UHMW.

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer