Share |

leadscrews


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Jeff Dayman on August 30, 2002 at 20:05:10:

anyone out there know a simple formula for calculating the torque input to a leadscrew's nut to get a given resultant force axial to the leadscrew?

In this system the nut is turned to move the leadscrew.

diameter, force output, and pitch are known. The thread is a 60 degree flank iso std thread. If there is a calculation with and without friction consideration please post it too.


Follow Ups



< "> Subject: Re: leadscrews

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer