Share |

Stainless steel pipe producing and "Centerline" indications


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Edward R.Cauffman on September 17, 2002 at 08:49:42:

I am a welding engineer for a tube and pipe facility and am currently battling with centerline indications on 2,3,and 4 inch pipe-- (300 series). Other than slowing welding speeds down is there a solution to this problem (ie; arc deflection)?
Any help with my current situation would be greatly appreciated.


Follow Ups



< "> Subject: Re: Stainless steel pipe producing and "Centerline" indications

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer