Share |

Re: Re: Spur Gear Design


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">ahmed on September 17, 2002 at 13:26:26:

In Reply to: Re: Spur Gear Design posted byserdar yorulmaz on July 24, 2002 at 22:35:37:

i have to design a supr gear and actualy i do notknow how to chooe the sutable material and also i foun this page and i want the help from you if you do not mind ,
the gear should be between two shafts that one of the should rotate at 3800 rpm and the other one at 1500 rpm ,so that the power transmeted is 2.5 hp ,and accordind to my study i choose a spur gear with 20 degree presure angle and so i want to fit the two gear (penion and the large gear within 7-8 in ) so could you please tell me the suitabe diameter for the penion and also the suitable material for desiging this gear


Follow Ups



< "> Subject: Re: Re: Re: Spur Gear Design

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer