Share |

Re: Porosity levels for high volume manufacturing


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Juan Espinoza Cuadra on September 25, 2002 at 17:39:12:

In Reply to: Porosity levels for high volume manufacturing posted byCengiz Halil Fehmi on March 15, 2002 at 12:24:58:

: Good day to all.

: What is the generally accepted fallout percentage for porosity in cast steel products. For our aluminum suppliers we use 1.5% as our allowable.

: Please email me a response

: Thankyou




Follow Ups



< "> Subject: Re: Re: Porosity levels for high volume manufacturing

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer