Share |

Re: Thickness tolerances for aluminum sheet stock


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Randy Kimball on October 04, 2002 at 22:36:26:

In Reply to: Thickness tolerances for aluminum sheet stock posted byJeff Moore on October 03, 2002 at 18:09:15:

Jeff,
Also, refer to this web page.
++++

http://www.evergreen.edu/biophysics/technotes/fabric/sheet_metal.htm

++++
There is a MIL-STD that covers thicknesses, however,
for the life of me I can't seem to come up with it.

I no longet have access to my MIL-STD and MIL-SPC racks.


Follow Ups



< "> Subject: Re: Re: Thickness tolerances for aluminum sheet stock

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer