Share |

Re: Re: Gearbox Design


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Mark Donnelly on October 06, 2002 at 21:27:22:

In Reply to: Re: Gearbox Design posted bySerdar Yorulmaz on October 06, 2002 at 09:40:34:

Serdar
My gearbox is a 3 shaft design with an input shaft with a torque (NOMIAL) 497.35Nm and a Torque (MAX)(as the torque developed by the motor during start-up is 1.6 times the steady state full load torque avaiable), and middle shaft with a torque of 1492.81 Nm (NOMIAL)Torque (MAX) 2387.32Nm and the output shaft Torque(NOMIAL) 4476.23Nm Torque (MAX) 716197Nm.

*Motor is 75KW
*All shafts are in the one plane
*one gear is on the input shaft
*two gears on the middle shaft
*one gear on the output shaft

Thank you for your previous quick response

-Mark



Follow Ups



< "> Subject: Re: Re: Re: Gearbox Design

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer