Share |

Re: Re: Re: Gearbox Design


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Mark Donnelly on October 06, 2002 at 21:39:02:

In Reply to: Re: Re: Gearbox Design posted byMark Donnelly on October 06, 2002 at 21:27:22:

As well i calculated the gear reduction to be 3:1, the gear reduction is the same for both gear reductions,
the input shaft is 1440 rpm
the middle shaft is 480 rpm
the output shaft is 160 rpm

-Mark



Follow Ups



< "> Subject: Re: Re: Re: Re: Gearbox Design

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer