Membership Services

Re: Re: Re: Gearbox Design

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Serdar Yorulmaz on October 11, 2002 at 15:36:38:

In Reply to: Re: Re: Gearbox Design posted byMark Donnelly on October 11, 2002 at 10:58:33:

For 18CrNi10 you can take
210,000 N/mm^2

: Serdar,
: i was wondering if you know the modulus of elasticity for the following materials are: (for the shafts)

: 15-5SS
: 4140HT
: 18CrNi10

: The reason behind this is so i can determine deflection in the shaft, the deflection I have to have is a maximum deflection of 0.035mm. As well how would I calculate the diameter of my shaft, i found a rather large formula to calculate the shaft but i was wondering if there is an easier way to calculate the diameter.
: Thanks in advance.

: -Mark

Follow Ups

Subject: Re: Re: Re: Re: Gearbox Design

Comments:: For 18CrNi10 you can take : 210,000 N/mm^2 : : Serdar, : : i was wondering if you know the modulus of elasticity for the following materials are: (for the shafts) : : 15-5SS : : 4140HT : : 18CrNi10 : : The reason behind this is so i can determine deflection in the shaft, the deflection I have to have is a maximum deflection of 0.035mm. As well how would I calculate the diameter of my shaft, i found a rather large formula to calculate the shaft but i was wondering if there is an easier way to calculate the diameter. : : Thanks in advance. : : -Mark

[ Home ][ Forum Archive ] [ Active Engineering Forum ]