Share |

Spring steel call-out for drawings


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">Paul Long on October 17, 2002 at 08:39:24:

I am trying to find a good material call-out for a drawing of a stamped, spring steel fuel filter bracket. Currently, the drawing calls for SAE J403 1050 spring steel, 1.25 mm thick, heat treatment to be austemper per NT2-7, RC 45-50. I do not know where this designation came from, and I haven't been able to find any good guides as to what it should say. Hope someone can help.

Thank you,


Follow Ups



< "> Subject: Re: Spring steel call-out for drawings

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer