Share |

Re: Flat latout for sheet metal rolled radially formula needed.


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted ByTony on October 19, 2002 at 07:57:25:

In Reply to: Flat latout for sheet metal rolled radially formula needed. posted byRalph Rivers on September 12, 2002 at 16:47:36:

(.01743xrad)+(.0078xthickness)x degree of circle(or bend).Hope this helps.


Follow Ups



< "> Subject: Re: Re: Flat latout for sheet metal rolled radially formula needed.

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer