Share |

Re: Drawing notes.


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted ByCragyon on October 21, 2002 at 10:14:47:

In Reply to: Drawing notes. posted byStephen G Martin on October 19, 2002 at 14:59:47:

"My question is, what specific type of information is required in the NOTES section of an mechanical engineering drawing for plastic parts?"

Generaly, the following:

Applicable Standards (if any) such as ASME Y14.5M - 1994 (GD&T)

General manufacturing standards notes, such as:

Draft (angle),Finish, special manufacturing processes, marking (identification), serialization, material

Anything not specifically covered in the standards that is important to the end-item product.



Follow Ups



< "> Subject: Re: Re: Drawing notes.

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer