Posted ByDustin on February 08, 2002 at 11:16:42:
In Reply to: Metric Shaft and Hole Tolerance posted bygoflyers on February 08, 2002 at 10:23:09:
: I need some advice on finding ISO tolerance for shafts and holes (h7, h6, ... etc). I know that there has to be a simple place to find this but all I can find are the sights that want $60 for the official spec.
: Thank You,
This page on Engineers Edge might help
< "> Subject: Re: Re: Metric Shaft and Hole Tolerance
[ Home ][ Forum Archive ] [ Active Engineering Forum ]
© Copyright 2000 - 2020, by Engineers Edge, LLC All rights reserved. Disclaimer