Share |

Re: Re: Re: Double Plus or Minus Tolerance


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Ed Giralico (64.80.35.18) on November 04, 2002 at 08:30:04:

In Reply to: Re: Re: Double Plus or Minus Tolerance posted by Randy Kimball on October 28, 2002 at 23:10:42:

Iv'e noticed this type of dimensioning on consumable tools such as drills and reamers. For instance: the machinery's handbook dimensions shank diameters of some reamers as -.001 to -.005 , and cutting diameters of reamers as +.0001 to +.0004. This way you can still call a 1/4 inch reamer a 1/4 inch reamer and not some odd-ball size ???? I'm not sure, but it seems legit. It insures shank fits to collets.





Follow Ups:



Post a Followup

< "> Subject: Re: Re: Re: Re: Double Plus or Minus Tolerance

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer