Share |

Re: Special Screw


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Randy Kimball (4.46.211.7) on November 09, 2002 at 10:23:32:

In Reply to: Special Screw posted by Domenick on November 07, 2002 at 07:29:20:

Domenick,
Not being a microwave wise engineer I still think I have
a simple answer worth trying in an experiment. I
think you need to plug the space between the
thread roots with a metalic substance, if I'm right.
So, I would look for a metalic thread sealant or
at least one that is not passive to your frequency
of wave length. Thus blocking the leakage.
... or perhaps I have caused you the think of a
similar route to take. I agree, a better class of thread
fit will help but can make the screws to expensive.
I'd contact some of the thread sealant/glue makers
about a product or a new product for this purpose.
I have found them responsive and always looking for
new examples of ways to sell new sealant/glue products.
.. good luck..


Follow Ups:



Post a Followup

< "> Subject: Re: Re: Special Screw

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer