Membership Services

True position tolerance zone

[ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Andy (195.11.194.228) on November 13, 2002 at 04:52:50:

How do you apply a true position tolerance to a hole without a diameter symbol preceeding the tolerance value?

I assume its two parallel planes along each axis. Is this correct?

Can someone point me to any online sites that explain this.

Thanks in advance

Andy

Follow Ups:

Re: True position tolerance zone John-Paul Belanger 22:57:05 11/22/02 Re: True position tolerance zone Randy Kimball 11:21:58 11/16/02
Re: True position tolerance zone Randy Kimball 11:17:05 11/16/02 (0)
Re: True position tolerance zone Jacek Palinski 14:20:22 11/14/02 (0)

Post a Followup

Subject: Re: True position tolerance zone

Comments:
: How do you apply a true position tolerance to a hole without a diameter symbol preceeding the tolerance value? : I assume its two parallel planes along each axis. Is this correct? : Can someone point me to any online sites that explain this. : Thanks in advance : Andy

[ Home ][ Forum Archive ] [ Active Engineering Forum ]