Share |

Re: parallelism


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Randy Kimball (4.46.211.7) on November 16, 2002 at 11:07:34:

In Reply to: parallelism posted by Don on November 15, 2002 at 17:52:07:

Don,
You'd get .010 in the ten inches, however you must still
be within the total thickness tolerance, also. The // tollerance
is stating .001 per inch.
-randy-


Follow Ups:



Post a Followup

< "> Subject: Re: Re: parallelism

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer