Share |

Re: Granulated plastic


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Randy Kimball (4.46.211.7) on November 28, 2002 at 12:10:45:

In Reply to: Granulated plastic posted by Mike on November 27, 2002 at 13:47:17:

Mike,
I've done this too, it has been years and I nearly forgot.
Most plastic injection companies use plastic in
the a form that looks a lot like rice and or shot. Heating
your tool and inserting into a cup of it does
indead result in a bonded coating of plastic,
but may need some dressing. I bet you could
get a small quanity of "bead" from an injection
shop supplier of a local shop.




Follow Ups:



Post a Followup

< "> Subject: Re: Re: Granulated plastic

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer