Share |

Re: Inspection dimension


[ Home ][ Forum Archive ] [ Active Engineering Forum ]

Posted By<" ">peterN on February 22, 2002 at 09:52:16:

In Reply to: Inspection dimension posted bySlawomir Kapusta on February 21, 2002 at 11:49:58:

Mr. Kapusta,

In response to your question, I must say first off, that I have no experience with SolidWorks. However, I have been a mechanical designer for 20+ years.

You describe the dimension as having 'an oblong box' which I recognize as a 'basic dimension' from ASME Y14.5M and/or ANSI Y14.5M

I believe you wish to 'translate' that 'dimension' as you have a need to build inspect to it. I can not (and will not) explain it as it is extensive and very well documented.

You may be able to find these specs (for sale) at globalspec.com (i may not have the web address totally correct.)

If you 'search' the internet, you may be able to find small tutorials on this system of tolerancing.

Good Luck - Peter N


Follow Ups



< "> Subject: Re: Re: Inspection dimension

Comments:

[ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer