Share |

Hole Position to -A- only


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Joe (207.138.117.66) on December 11, 2002 at 15:49:53:

I am familiar with checking position of holes to A-B-C datums, but I do not understand how to check the position of a hole to -A- datum only, can anyone help?
Thanks


Follow Ups:



Post a Followup

< "> Subject: Re: Hole Position to -A- only

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer