Share |

Molding ABS With Metallic Pigments


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Jim Nicely (68.47.185.63) on December 12, 2002 at 11:07:59:

Screw and Ram injection molding, having real difficulty
getting rid of mate lines and flow marks.
Any suggestions would be greatly appreciated


Follow Ups:



Post a Followup

< "> Subject: Re: Molding ABS With Metallic Pigments

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer