Share |

Re: Surface Finish


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Jarrad Norcutt (207.34.59.179) on December 15, 2002 at 20:19:56:

In Reply to: Surface Finish posted by George Bradley on November 27, 2002 at 12:07:18:

: I saw that you have a chart that shows what different surface textures are achieved by the different manufacturing techniques, but can I buy a set of gauges or plates with the labeled surfaces on them?
: Kind of like a thread gauge.




Follow Ups:



Post a Followup

< "> Subject: Re: Re: Surface Finish

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer