Share |

Cones


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ] [ Design & Engineering Data ]

Posted by Taylor (206.66.235.75) on December 31, 2002 at 10:56:13:

If anyone has experience creating flat layouts for cones. The cone is 7'-6 1/16" ID 6ft in height and minor Dia is 6 5/8". Material is 10 ga. I will need to nest on 7' x 8' sheet. Any info anyone could give would be appreciated!


Follow Ups:



Post a Followup

< "> Subject: Re: Cones

Comments:


[ Follow Ups ] [ [ Home ][ Forum Archive ] [ Active Engineering Forum ]

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer