Replies to this message

Re: .dwg to .jpg
Re: .dwg to .jpg -- Jennifer	Post Reply	Top of thread	Forum

Posted by: Andy 03/26/2003, 07:55:01 Edit

Plot drawing as a pdf file then open the pdf in coreldraw and re-export as an wmf (windows meta file) which is a vector format and is great for word. BTW you can adjust the resolution of the JPEGS and tiffs that Autocad creates.

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

Re: .dwg to .jpg
Re: .dwg to .jpg -- Jennifer	Post Reply	Top of thread	Forum

Posted by: Milton Beychok 03/18/2003, 18:16:34 Edit

Jennifer: Print a hard copy of your drawing on paper. Then photograph your drawing with a digital camera. The resulting photo will be a .jpg file. Milton Beychok

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

| |

Re: .dwg to .jpg
Re: .dwg to .jpg -- Jennifer	Post Reply	Top of thread	Forum

Posted by: Antonio Patino 03/12/2003, 16:23:48 Edit

On Autocad there is an export aplication, not very sharp. another way to go is to fit the best you can to the screen what you want to copy, then press the "print Scrn" button, then paste it in paint brush as BMP, then save as to JPG. Hope it works for you : I need to take a section of a drawing and make it a .jpg or related format so I may use it in Microsoft word. I am in Land Development 2i and have tried to figure it out. I have gotten it to work, but the image is fuzzy and hardly readable or not very sharp. Any advice?

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread

| |