Engineers Edge

[Home] [Design Resources] [Engineering Jobs] [Tell A Friend] [Technology Store]

Re: Casting Tolerance
Re: Casting Tolerance -- Percy Post Reply Top of thread Forum
Posted by: C. W.

03/13/2003, 11:28:17

It means(+/- .03) + .005 per inchThe first portion tolerance must be based on a basic size, which should be shown on the drawing, then the second portion will be added on for every inch longer.Hope this helps.CW

Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer