|
Vertical shaft support | |||
Post Reply | Engineering Forum |
Posted by: miltop ® 02/10/2009, 18:40:20 Author Profile eMail author Edit |
Hi, I'm trying to figure out a way to support a vertical support. In this picture - its the short shaft above the spur gear. I was thinking about a stepped end of the shaft supported by a cylindrical thrust roller bearing. I just cant seem to get my head around how would the step rest on the bearing... Would you know any better solutions - I couldnt find any good info on vertical shaft supports. Here's a render: [url=https://imageshack.us][img=https://img214.imageshack.us/img214/1251/earlyver32qz5.jpg][/url] I'd really appreciate any help Cheers
|
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
View All | | Next | |
Replies to this message |
: Vertical shaft support | |||
: Vertical shaft support -- miltop | Post Reply | Top of thread | Engineering Forum |
Posted by: randykimball ® 02/11/2009, 08:41:30 Author Profile eMail author Edit |
Alter the end cap on the pump or what ever that is to include a bearing at the location of that shaft end. This will maintain the gear pitch alignment, too. The end cap would be kind of peanut shaped with the bearing off to one side. The worst suggestion of your lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. |
Post Reply Tell a Friend (must be logged in) Alert Admin About Post |
Where am I? Original Top of thread | | | |
© Copyright 2000 - 2024, by Engineers Edge, LLC All rights reserved. Disclaimer