[Home] [Design Resources] [Technology Store]
[Archive#1] [Archive #2] [Archive #3] [Calculators]
Help on bonding to power paint
Post Reply   Forum
Posted by: oscamacho ®
Huckleberry
05/13/2003, 09:45:09

Author Profile Mail author Edit
I need to bond a nylon based Velcro to a powder coated surface, I have talked to 3M and they recommend their 300LSE family of adhesives, however they only come on tapes, I would rather not use tape for manufaturing purpose. Any one knows of a solvent type adhesive that I can use? I appreciate the help.






Post Reply | Recommend | Alert Rate View All   Previous | |

Replies to this message


Re: Help on bonding to power paint
Re: Help on bonding to power paint -- oscamacho Post Reply Top of thread Forum
Posted by: Cragyon ®
Barney
05/13/2003, 10:59:33

Author Profile Mail author Edit

 I estimate that you will need a mil spec or equivalent approved material.  There is an adhesive called "Scotch Weld 2216" that is widely used in the defense - space industries. Check it it out.  I believe scotchweld sticks to most anything, and is very rugged. 

 







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread Previous | |
Re: Help on bonding to power paint
Re: Re: Help on bonding to power paint -- Cragyon Post Reply Top of thread Forum
Posted by: oscamacho ®
Huckleberry
05/13/2003, 11:42:15

Author Profile Mail author Edit
Thanks for the info, I'll check it out.





Modified by oscamacho at Tue, May 13, 2003, 11:42:37

Post Reply | Recommend | Alert Rate Where am I? Original Top of thread Previous |   |
Re: Help on bonding to power paint Question
Re: Help on bonding to power paint -- oscamacho Post Reply Top of thread Forum
Posted by: Cragyon ®
Barney
05/13/2003, 09:52:53

Author Profile Mail author Edit

What industry are you in? Aerospace, commercial? What are your environmentals?

The tape may be adequate for your application.  If you want to bond or chemically adhere the material contact the manufacturer of the Nylon type material and see what they reccommend.







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread Previous | |
Re: Help on bonding to power paint Smile
Re: Re: Help on bonding to power paint -- Cragyon Post Reply Top of thread Forum
Posted by: oscamacho ®
Huckleberry
05/13/2003, 10:04:48

Author Profile Mail author Edit
We are in the defense industry.

The Nylon based Velcro that I am using is also from 3M, and they are the ones that recommended the tape adhesive. I have also talked to DOW and Materbond; they don’t seem to have a product that I can use.







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread Previous |   |

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer