[Home] [Design Resources] [Technology Store]
[Archive#1] [Archive #2] [Archive #3] [Calculators]
alum threads stripping Question
Post Reply   Forum
Posted by: sheridan atho

05/13/2003, 12:30:28

Author Profile Mail author Edit
I need to know the torque allowance for a 6/32 tapped hole with a depth of 13mm in alum.






Post Reply | Recommend | Alert Rate View All   Previous | Next |

Replies to this message


Re: alum threads stripping Agree
Re: alum threads stripping -- sheridan Post Reply Top of thread Forum
Posted by: Cragyon
Barney
05/13/2003, 13:29:52

Author Profile Mail author Edit

Check out the following page on engineers edge.

/torque.htm

 

We use a standard torque of 10 in-lbs for a stainless fastener in aluminum (6061-T651), assuming 1.5 D thread engagement.







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread Previous |   |

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer