Engineers Edge

[Home] [Design Resources] [Engineering Jobs] [Tell A Friend] [Technology Store]

Re: Angularity and Profile of Surface
Post Reply   Forum
Posted by: D. Day on December 10, 2001 at 14:16:33:



12/10/2001, 14:16:33


Edit

In Reply to: Angularity and Profile of Surface
posted byCabano on December 09, 2001 at 11:49:25:
: What is the real difference between angularity and profile of a surface. Are'nt they interchangable, same thing?: There is a hierarchy to GD&T. In general first is location then orientation followed by size and form. Profile of a surface is a locational control provided basic dimensions are used to describe a feature relative to a datum reference frame. If a feature is located, its orientation (angularity) is also controlled to that degree. Angularity could be added as a refinement if needed. Angularity alone is only an orientation control and does not locate, even if basic dimensions are present. A good rule of thumb is to use profile of a surface first, rather than angularity.








Post Reply | Recommend | Alert Rate   | Next |

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer