Design and Engineering Forum
[Home] [Design Resources] [Technology Store]
[Archive#1] [Archive #2] [Archive #3] [Calculators]

Mounting of Carden shafts (flexible shaft)
Post Reply   Forum
Posted by: antony

02/20/2004, 21:57:23

Author Profile Mail author Edit

We are using a carden shaft to connect two parallel shafts, one of which is translating up & down. In other words, one end of the carden shaft is stationary & the other end is moving up & down (oscillating)

My question is that whether the application of carden shaft  is correct or not?

Carden shaft rotates at the speed of 1800 rpm and it oscillates through the total angle of 32 degrees. (+16 degrees to -16 degrees).

Thank you,

C.M.Antony Thomas







Post Reply | Recommend | Alert Rate  

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer