cylinder working power
	Post Reply		Forum

Replies to this message

Re: cylinder working power
Re: cylinder working power -- snapper	Post Reply	Top of thread	Forum

Posted by: RandyKimball ® 05/15/2004, 10:07:16 Author Profile Mail author Edit

Snapper, hi, Clyinder working forces has nothing to do with stroke length unless you are figuring torque at a crank or leverage. .. you do need the pressure in the chamber. The blind side of the cylinder forces are (pi X r² X pressure) ..the blind side has no rod sticking out.. The rod side is (pi X r² X pressure) - (pi X r² [of the rod] X pressure) or ((dia of cylinder - dia of rod)/2)² X pi X pressure) I hope that helps. The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them. Modified by RandyKimball at Sat, May 15, 2004, 10:13:30

Post Reply | Recommend | Alert

Rate

Where am I? Original Top of thread