Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

shear center Smile
Post Reply   Forum
Posted by: frank78

05/25/2004, 06:33:43

Author Profile Mail author Edit
Hello,

Does anyone have any suggestions for real-life practical uses for knowing the shear center of sections?
Thanks in advance!







Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message


Re: shear center
Re: shear center -- frank78 Post Reply Top of thread Forum
Posted by: acroduster1

06/03/2004, 08:26:07

Author Profile Mail author Edit
If an unsupported channel section is loaded closer to its shear center, it'll take more load before buckling than if you put the load over the center of the channel, the application being that you can get more load out of the same member.



Acro


Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer