Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

screw conveyor design Question
Post Reply   Forum
Posted by: freak_scil

06/08/2004, 08:50:56

Author Profile Mail author Edit

hi folks

these days i m experiencing a problem that how i can calculate a screw in flat form which can meet the following parameters

shaft size is 60 mm

screw OD is 150 mm

screw pitch is 170 mm

now can some one help me in calculation of the ID of the screw

if there is more help is available in this regard i m awaiting for the reply







Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message


Re: screw conveyor design
Re: screw conveyor design -- freak_scil Post Reply Top of thread Forum
Posted by: jcmcgraw
Huckleberry
06/09/2004, 08:58:22

Author Profile Mail author Edit
If I am not mistaken, you can go back a few pages in the forum and find all the answers to your questions. If I remember correctly there is a thread on here that covers this same problem in great detail.

Good Luck







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer