Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

Autodesk - Inventor 7 Design software
Post Reply   Forum
Posted by: Camillion21

06/21/2004, 10:45:12

Author Profile Mail author Edit
Hello - New to forum and also new to a software package recently purchased for our design team. Any one familiar with this? Ant feedback on it's pros and cons?? From my vantage point, it beats the heck out of Auto-Cad!!






Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message


Autodesk - Inventor 7 Design software Agree
Re: Autodesk - Inventor 7 Design software -- Camillion21 Post Reply Top of thread Forum
Posted by: RandyKimball
Barney
06/24/2004, 18:57:02

Author Profile Mail author Edit
My CAD software of choice. ...
Wouldn't take for it.
I like the ease of design and assembly constraints.
It is a bit sticky to pick an edge to constrain in assemblies at times though.
My version will not do stress and strain, Mechanical Desktop will.
I most like the moving parts links, impressive and has saved me many "would-be" scrapped R&D models. I no longer do a prototype. I prototype in Inventor.
-randy-



The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.


Post Reply | Recommend | Alert Rate Where am I? Original Top of thread
Re: Autodesk - Inventor 7 Design software Smile
Re: Autodesk - Inventor 7 Design software -- Camillion21 Post Reply Top of thread Forum
Posted by: johns

06/23/2004, 01:21:58

Author Profile Mail author Edit

Hi

I Have been Using inventor since the version 6 release and have found it to be super.  Many good macros and functions give us a yell if you have any problems.







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread | |
Re: Autodesk - Inventor 7 Design software
Re: Re: Autodesk - Inventor 7 Design software -- johns Post Reply Top of thread Forum
Posted by: Camillion21

06/28/2004, 11:40:23

Author Profile Mail author Edit

Hey, sorry it took so long to get back - very busy in the cubicle world.

I appreciate the feedback - I will be attending a school in Omaha on I7 and will (hopefully) have all questions resolved. I will post again if I run into a snag and thanks for the help in advance to all.







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer