Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

clearance calculation Question
Post Reply   Forum
Posted by: Lu5ck

08/03/2004, 05:32:53

Author Profile Mail author Edit

i doin a project on clearance on forming, blanking, punching, piercing on stamping process. I a outsider on engineering manufacturing...so i gotta do research abt it and is so confusing and hard to find the forumla for clearance.

any kind soul can tell mi the clearance formula for these process?







Post Reply | Recommend | Alert Rate View All   | Next |

Replies to this message


Re: clearance calculation Smile
Re: clearance calculation -- Lu5ck Post Reply Top of thread Forum
Posted by: Cragyon
Bart
08/04/2004, 08:43:27

Author Profile Mail author Edit
Clearance between mating parts (if this is what you are reffering to) is typically determined by limits and fit standards. There may be a formula however, I am not aware of any.

Check out the following link /tolerance_chart.htm

.







Post Reply | Recommend | Alert Rate Where am I? Original Top of thread | |
Re: clearance calculation
Re: Re: clearance calculation -- Cragyon Post Reply Top of thread Forum
Posted by: Lu5ck

08/04/2004, 09:07:45

Author Profile Mail author Edit
ermm...i mean the clearance...for stamping u nid to hav some space between the hole and the tool rite...if i not wrong






Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer