Design and Engineering Forum
[Home] [Design Resources]
[ POSTING POLICY / RULES ][Archive#1] [Archive #2] [Archive #3] [Calculators]

Inventor Views
Post Reply   Forum
Posted by: Dustin_Pitt

09/02/2004, 14:11:32

Author Profile Mail author Edit

I'm a beginner with Inventor and I am having some troubles with my views.  When I am trying to put my assembly onto my drawing space it is not showing up as a true front view.  I don't know if there is something that is similar to UCS's the AutoCAD uses.  I could really use some help with this.

 

Thanks,

Dustin VanErem







Post Reply | Recommend | Alert Rate View All   | |

Replies to this message


Inventor views
Re: Inventor Views -- Dustin_Pitt Post Reply Top of thread Forum
Posted by: randykimball
Barney
09/03/2004, 00:01:38

Author Profile Mail author Edit
Dustin,
In the top tool bar there is an icon that looks a little like a page blowing in the wind. On my desk top it is the most right icon in the center group. If you click it and hold the cursor over a face on the part that face will get a glow around the rim. If you click the mouse again the part will turn and face you with that face. You will learn to love it!

-randy-




The worst suggestion of you lifetime may be the catalyst to the grandest idea of the century, never let suggestions go unsaid nor fail to listen to them.


Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Powered by Engineers Edge

© Copyright 2000 - 2018, by Engineers Edge, LLC All rights reserved.  Disclaimer