C-RING DESIGN

C-RING DESIGN
	Post Reply		Forum

Posted by: DLTOOLDESIGN ^®

11/11/2004, 14:56:24

Author Profile Mail author Edit

Hi,
I'm looking for a formula that will predict the axial force required to make a C-ring jump from a groove on a shaft.
The variables I would expect would be:
1.OD and ID of C-ring
2.Length of ring
3.depth of groove
4.angle of the sides of the groove and mating edges of the ring.

The ring will be of 4140 26-36 Rc steel.

Thanks,
DLTOOLDESIGN

Post Reply | Recommend | Alert

Rate

View All

| Next |

Replies to this message

Re: C-RING DESIGN

Re: C-RING DESIGN -- DLTOOLDESIGN Post Reply Top of thread Forum

Posted by: zekeman ^®

11/13/2004, 09:30:47

Author Profile Mail author Edit

Good question. I assume you are talking about a retainer ring. If so, go to the manufacturer, They should have this.

Post Reply | Recommend | Alert Rate Where am I? Original Top of thread

Re: C-RING DESIGN
Re: C-RING DESIGN -- DLTOOLDESIGN	Post Reply	Top of thread	Forum